3D project

I was having a go at making a box to hold some choccies in for christmas gifts.  I came across this link from another blog, but cannot remember where from, so I am sorry I cannot give credit where credit is due.

I have used Bazzil cardstock here, which is a bit flimsy when the cup is full (at the moment it is holding five 2-finger chocolate biscuit bars).  But as a proto-type at least it worked out. My piece of cardstock was 27cm x 16.5cm.  Vertical scoring was every 3cm (making 9 sections - 9th section cut as a tab to glue inside cup).
The horizontal scoring line is approximately one-third of the vertical side.  Cut slits up to the score line on the vertical scores to make the strips to form the base.  The handle was cut using circle nesties.  Will do this design again, and I think it will work with thicker cardstock, and larger tabs to secure the handle.

As this was done with an already cut-into piece of 12x12 cardstock, I shall be playing in the snippet playground.  I wonder if all the pumpkins have gone yet?!